How Can I See The Data?

 

By: Kevin Rivard



Question: How can I see the data?

Answer: Both Delta and WipFrag produce a % passing or retained curve visible after each sieve. It also saves the data to a CSV (comma-separated values) file. Each sieve analysis produces a new line in the CSV file that represents the results from the sieve.

This CSV file contains:
- Timestamp (Year/Month/Day/Hour/Minute/Second)
- D-values (XX% passed the specified size - Ex. 90% of the material passes 13.87 inches[352.30mm])
- User specified size classes (% passing or retained at the specified size)
- Block (amount of particle detected)
- Min, Max, Mean, St. Dev, Mode
- Sphericity (The shape of the material - 0=Linear Objects 1=Perfectly Round)
- Coverage (How much of the image is used)
- Calibration Values (b, Xmax, X50, Xc and n)
- EDP values (Edge Detection Values)
- Calibration factors
- System info (CPU temp, Board temp, Voltage checks)
- System uptime
- Camera setting at the time of the image.
- Modbus and OPC poll rate
- Vehicle Identification Information (Reflex Only)

Delta can e-mail these CSV files automatically as well as an average of the entire day on one passing curve. It also has a trending graph in the lower section of the software interface which trends the data for the current day.

In addition, Delta has the ability to output the analysis information using a Modbus or OPC connection to pass information on to your historian, PLC or HMI.


How Can I See The Data?